Which receivers can I use?
RadioMaster radios equipped with multi-protocol modules are compatible with a wide range of receivers, enabling you to use various brands and models. The key to determining compatibility is to identify the communication protocol used by your receiver and confirm the multi-protocol module supports it. This guide will walk you through the process.
Step 1: Identify your receiver's protocol
To find out which protocol your receiver uses:
- Check the documentation: Look at the receiver’s user manual or product packaging.
- Inspect the receiver: Some receivers have labels or markings indicating the protocol.
- Search online: Use the receiver’s model number to find details on the manufacturer’s website or forums.
Common protocols include Frsky, DSMX, Flysky, and Futaba S-FHSS, but many others may also be supported.
Step 2: Check if the protocol is supported
The multi-protocol module supports a broad range of protocols, but this list is continually evolving as new protocols are added or updated. For the latest information, visit the multi-module supported protocols page.
If your receiver’s protocol is listed, your RadioMaster radio should be compatible with it.
Step 3: Binding your receiver
Binding procedures vary by manufacturer and receiver model. To bind your receiver:
- Consult the manufacturer: Check the receiver’s manual or the manufacturer’s website for specific binding instructions.
- Follow the steps: Procedures vary widely, so follow the guidance provided.
General examples (always verify with your receiver’s instructions):
- FrSky receivers: Typically, press the bind button on the receiver while it is powered on, then select the bind option on your radio.
- DSMX receivers: Often require inserting a bind plug into the receiver, powering it on, and then initiating bind mode on the radio.
Step 4: Configure your radio (if necessary)
Some receivers need specific radio settings to work correctly, such as:
- Selecting the correct sub-protocol.
- Enabling telemetry.
- Adjusting other parameters.
Refer to your receiver’s documentation for any required configurations.
Step 5: Test your setup
After binding, test the receiver with your radio to confirm that all controls and features (e.g., telemetry) work as expected. If issues arise, revisit your binding procedure, protocol selection, or settings.
Using bind-and-fly (BNF) models
For BNF models with pre-installed receivers:
- Find the protocol: Check the model’s documentation or the manufacturer’s website.
- Follow the steps above: Confirm compatibility and bind the receiver using the outlined process.
Additional tips
- Update your firmware: Ensure your radio’s firmware is up to date, as updates may enhance protocol support or compatibility.
- Need help? If binding fails or features don’t work, visit the RadioMaster community forums or contact support for assistance.
By following these steps, you can determine which receivers are compatible with your RadioMaster radio and get them working successfully.