Welcome to the EdgeTX Video Series
This video series is designed to help you start with EdgeTX, from initial setup to configuring advanced radio functions. Whether new to EdgeTX or just looking to refine your skills, each episode offers practical guidance to help you get the most out of your radio system.
Table of Contents
Episode 01 – Welcome to EdgeTX
An overview of EdgeTX, what makes it unique, and what to expect from this series.
Episode 02 – How to Flash/Update Firmware
Step-by-step instructions on how to flash EdgeTX to your radio or update it to the latest version.
Episode 03 – Radio Setup
Initial configuration and calibration steps to get your radio ready for use.
Episode 04 – Mixer Basics
I'd like to know how the Mixer works and how to configure basic mixes for your models.
Episode 05 – Dual Rates (Inputs Screen)
How to set up dual rates and expos using the Inputs screen for smoother control.
Episode 06 – Endpoints (Outputs Screen)
Adjusting travel limits and endpoints on servos using the Outputs screen.
Episode 07 – Model Management
Creating, renaming, copying, and deleting models on your radio.
Episode 08 – Model Settings
Configuring essential model-specific settings including timers, preflight checks, and warnings.
Episode 09 – Special Functions
How to assign custom functions to switches, buttons, and triggers for added functionality.
Episode 01: Welcome to EdgeTX
Episode 02: How to flash/update Firmware
Episode 3: Radio Setup
Episode 4: Mixer Basics
Episode 5: Dual rates (Inputs Screen)
Episode 6: Endpoints (Outputs Screen)
Episode 7: Model management
Episode 8: Model Settings
Episode 9: Special Functions